Pass4Test のHPのHP0-Y43問題集は最も徹底的で、最も正確で、かつアップ·ツー·デートなものです。当面の市場であなたに初めて困難を乗り越える信心を差し上げられるユニークなソフトです。HPのHP0-Y43認証試験は世界でどの国でも承認されて、すべての国が分け隔てをしないの試験です。Pass4Test のHPのHP0-Y43認証証明書はあなたが自分の知識と技能を高めることに助けになれることだけでなく、さまざまな条件であなたのキャリアを助けることもできます。Pass4Test のHPのHP0-Y43問題集を利用することをお勧めいたします。
HPのHP0-Y43認定試験と言ったら、人々は迷っています。異なる考えがありますが、要約は試験が大変難しいことです。HPのHP0-Y43認定試験は確かに難しい試験ですが、Pass4Test を選んだら、これは大丈夫です。Pass4TestのHPのHP0-Y43試験トレーニング資料は受験生としてのあなたが欠くことができない資料です。それは受験生のために特別に作成したものですから、１００パーセントの合格率を保証します。信じないになら、Pass4Testのサイトをクリックしてください。購入する人々が大変多いですから、あなたもミスしないで速くショッピングカートに入れましょう。
君はまずネットで無料な部分のHP認証試験をダウンロードして現場の試験の雰囲気を感じて試験に上手になりますよ。HPのHP0-Y43認証試験に失敗したら弊社は全額で返金するのを保証いたします。
もし君がHPのHP0-Y43に参加すれば、良い学習のツルを選ぶすべきです。HPのHP0-Y43認定試験はIT業界の中でとても重要な認証試験で、合格するために良い訓練方法で準備をしなければなりません。。
HPのHP0-Y43認定試験は全てのIT職員にとって大変重要な試験です。この試験に受かったら、あなたは絶対職場に廃れられることはありません。しかも、昇進と高給も実現できます。HPのHP0-Y43試験に受かったら成功への鍵を握ったと言った人もいます。これは間違いないです。Pass4TestのHPのHP0-Y43試験トレーニング資料はあなたが成功へのショートカットです。このトレーニング資料を持っていたら、成功への道を見つけます。
試験番号：HP0-Y43問題集
試験科目：HP 「Implementing HP Network Infrastructure Solutions Exam」
一年間無料で問題集をアップデートするサービスを提供いたします
最近更新時間：2014-03-10
問題と解答：全62問
難しいHP0-Y43認定試験に合格したいなら、試験の準備をするときに関連する参考書を使わないとダメです。自分に合っている優秀な参考資料がほしいとしたら、一番来るべき場所はPass4Testです。Pass4Testの知名度が高くて、IT認定試験に関連するいろいろな優秀な問題集を持っています。それに、すべてのHP0-Y43試験問題集に対する無料なdemoがあります。Pass4TestのHP0-Y43問題集があなたに適するかどうかを確認したいなら、まず問題集のデモをダウンロードして体験してください。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.pass4test.jp/HP0-Y43.html
NO.1 A company has a service level agreement (SLA) with its service provider. The SLA specifies a 2 Mbps
committed information rate (CIR) and 20 KB committed burst size (CBS). Lately, during peak usage times,
the company has been experiencing brief periods of poor performance on its external connection
(GigabitEthernet port 2/0/1 on an HP 5800 switch).
How can the network administrator configure the Comware switch to address this problem?
A. Configure a traffic classifier that selects all traffic and a car traffic behavior that sets the CIR to 2 Mbps
and the CBS to 20 KB. Create a QoS policy that maps the classifier to the action and apply this policy as
an inbound policy on port GigabitEthernet 2/0/1.
B. Enable Strict Priority (SP) scheduling on port GigabitEthernet 2/0/1 and ensure that all inbound traffic is
marked with the correct priority.
C. Configure generic traffic shaping (GTS) on the GigabitEthernet port 2/0/1, setting the CIR to 2 Mbps
and the CBS to 20 KB.
D. Configure a traffic classifier that selects all traffic and a car traffic behavior that sets the CIR to 2 Mbps
and the CBS to 20 KB. Create a OoS policy that maps the classifier to the action and apply this policy as
an outbound policy on port GigabitEthernet 2/0/1.
Answer: C
HP HP0-Y43 HP0-Y43 HP0-Y43認定試験 HP0-Y43問題集
NO.2 How can a high density of ports and high throughput at the core of an HP FlexNetwork save customers
money?
A. Intelligence is offloaded from the edge switches, enabling customers to save money on the most
numerous switches in their solutions.
B. The customer can combine the data center and campus LAN core into a single entity, reducing power
and cooling costs.
C. The customer no longer needs to deploy modular switches at the distribution level and the edge,
deploying more cost-effective stackable switches instead.
D. The architecture can be simplified, eliminating expensive distribution devices and reducing power and
cooling costs.
Answer: D
HP認定証 HP0-Y43 HP0-Y43
NO.3 A customer requires an HP FlexCampus solution with a core that scales to 40/100G. Which HP switch
fabric meets this need?
A. the 7500's CLOS switch fabric
B. the 10500's CLOS switch fabric
C. the 7500's crossbar switch fabric
D. the 10500's crossbar switch fabric
Answer: B
HP練習問題 HP0-Y43 HP0-Y43 HP0-Y43参考書 HP0-Y43
NO.4 View the exhibit.
A network administrator wants to configure an HP 5800 switch to place all incoming traffic on the
GigabitEthernet 1/0/1 port in priority queue 3. However, one exception applies. All traffic incoming on that
port that is destined to UDP port 55555 should be forwarded in priority queue 4 and marked with DSCP
32.
Based on the current configurations shown in the exhibit, which further steps must the network
administrator perform? (Select two.)
A. Configure port GigabitEthernet 1>0/1 to trust DSCP
B. Apply QoS policy Policy1 as on inbound policyon port GigabitEthernet 1/0/l
C. Apply QoS policy Policy2 as on inbound policyon port GigabitEthernet 1/0/1
D. Create a OoS Ip-dscp mapthat maps Ip value 4 to DSCP02
E. Undo OoS trust on port GigabitEthernet 1/0/1
Answer: B,E
HP HP0-Y43 HP0-Y43 HP0-Y43過去問
NO.5 View the exhibits.
Exhibit 1
The frame has these characteristics:
-VLANID = 3
-802.1p = 3
-DSCP=32
-Source IP address = 10.1.1.5
Click here for Exhibit 2
The frame shown in Exhibit 1 arrives on an HP 5800 switch's GigabitEthernet port 1/0/1. QoS maps are at
their default settings. Based on the configuration shown in Exhibit 2, to which queue is the outbound
packet assigned?
A. 2
B. 3
C. 4
D. 5
Answer: D
HP HP0-Y43 HP0-Y43
NO.6 View the exhibit.
The exhibit shows a network with HP 5400 zl and 8200 zl switches throughout the core and edge. What is
one advantage of implementing routing on edge switches?
A. Typically, it is easier to implement user-based VLAN assignments.
B. The topology has higher redundancy because edge switches can take over routing roles when
necessary.
C. Typically, the network can use fewer total VLANs when edge switches implement routing.
D. Typically, it is easier to ensure that routed links between edge and core switches are fully utilized.
Answer: D
HP参考書 HP0-Y43 HP0-Y43認証試験 HP0-Y43認証試験
NO.7 A network includes a mix of IGMPv2 and IGMPv3 endpoints and must support the following source
specific multicasting applications:
-Source: 10.1.4.2 and Group: 232.0.5.5
-Source: 10.1.4.12 and Group 232.0.6.6
The network is already implementing PIM-SM and IGMPv3. In order to support these applications, the HP
10500 switches that act as routers for the endpoints in question must support another feature. Which step
must the network administrator perform on each of these switches?
A. Create an SSM policy that includes 232.0.5.5 and 232.0.6.6 within its range
B. Enable IGMPv2 backward compatibility mode
C. Configure two SSM maps, each of which mapsa source to its multicast group
D. Enable PIM SSM on the interfaces that connect to the endpoints
Answer: C
HP HP0-Y43練習問題 HP0-Y43
NO.8 Which switch is best suited to act at the edge of a medium to large HP FlexFabric solution?
A. 10500
B. 5500
C. 9500
D. 5830
Answer: D
HP練習問題 HP0-Y43 HP0-Y43 HP0-Y43 HP0-Y43練習問題 HP0-Y43
NO.9 What is the role of neighbor solicitation (NS) messages in the autoconfiguration of an IPv6 address.?
A. An IPv6 node sends an NS message to inform a node undergoing autoconfiguration that it is already
using a particular address.
B. An IPv6 node sends an NS message for its tentative address to determine whether another node is
using it.
C. An IPv6 node sends an NS message for the global prefix to prompt other IPv6 nodes to advertise the
addresses that they are using on that prefix.
D. An IPv6 node sends an NS message to prompt an IPv6 router on the link to advertise the global
prefixes associated with the link immediately.
Answer: B
HP HP0-Y43 HP0-Y43
NO.10 A company has a network that includes HP 5800 and 12500 switches. Usage demands on the
company's FTP servers have increased, causing performance issues during peak usage times. While
analyzing link utilization, the network administrator noticed that the most heavily utilized links experience
bursts of congestion, causing them to drop traffic. The links then experience brief periods of low utilization
followed by another burst of congestion. This pattern continues periodically throughout the peak utilization
time.
What should the network administrator do to attempt to create a more efficient traffic pattern on these
links?
A. Configure an outbound traffic policing policy on the ports in question, setting the CIR at about sixty
percent of the ports' capacity and the PIR at about eighty percent.
B. Apply Weighted Fair Queuing (WFQ) or Weighted Round Robin (WRR) scheduling in preference to
Strict Priority (SP) scheduling on the ports in question.
C. Configure inbound traffic policing policies on ports at the core, setting the CIR at about sixty percent of
the ports' capacity and the PIR at about eighty percent. Apply outbound generic traffic shaping (GTS) on
ports facing the core ports, setting the CIR equal to the CIR on the core ports.
D. Apply a WRED table to the ports in question, optionally adjusting the table values to drop lower priority
traffic first.
Answer: D
HP参考書 HP0-Y43 HP0-Y43 HP0-Y43認定試験
Pass4Testは最新の000-089試験問題集と高品質のHP2-Z24認定試験の問題と回答を提供します。Pass4Testの70-492 VCEテストエンジンとLOT-407試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質のHP2-N40トレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100％保証します。試験に合格して認証資格を取るのはそのような簡単なことです。
没有评论:
发表评论